The RSM-1-RBU-RHU Skid-Mounted Pumping Station is our Baptismal Font Skid System. It consists of a reinforced 11 gauge, mill finish stainless steel platform with leveling feet, measuring approximately 2′-8″ wide x 4′-3″ long. The system includes a self-priming pump with integral strainer, an RCCF-050 50 S.F. cartridge filter with pressure gauge and air relief valve, erosion-type, in-line chemical feeder with metering valve and necessary fittings, and an RHU-Series electric heater unit with on-board controls. The unit also features a pump motor circuit breaker/load center time clock, as well as all necessary piping, fittings, manual regulating/isolation valves and check valves. Unit is pre-plumbed (Schedule 80 PVC) and factory tested, prior to shipment. Please refer to the cut sheet for available models, pump curves, power requirements, and additional information. NOTES: RHU-Series Kw heater operates as a ‘stand-alone’ unit and requires a separate 230 volt, single phase, 2-wire feeder GND. @ 60.0 F.L.A. It does not route through the control panel. Dual Heaters run in parallel may be required. Allow adequate space around entire skid system for servicing, maintenance, and electrical code clearances. Provide adequate ventilation (min. 25 CFM/H.P) and a floor drain. Documentation & Downloads 7.114 RSM-1-RBU-RHU Skid-Mounted Pumping Station Cad File DWG | 384 KB 7.114 RSM-1-RBU-RHU Skid-Mounted Pumping Station Cut Sheet PDF | 190 KB
