The RHSP Series Heavy Duty Bronze Submersible Pump is a heavy duty pump designed for general pumping service for submersible, in-fountain locations. This unit is of all bronze body construction with a 264 square inch wrap around stainless steel perforated suction screen (5/32″ dia. openings), Ceramic-carbon seal, permanent split capacitor motor, and built-in automatic current and thermal overload protection. The RHSP Series features an oil-filled motor chamber with diaphragm pressure equalizer, oil-filled shaft chamber, floor mounting brackets and 9 ft. of 16-3 submersible cable and floor mounting brackets. It is available in 1/3 H.P. to 3/4 H.P in a 120 volt, single phase 60 Hz as well as 1 H.P. to 2 H.P/230 volt, single phase. Outlet is 1 3/4″ O.D. for hose and clamp connection. This unit is U.L. Listed. Please refer to the cut sheet for technical and hydraulic data, as well as pump curves. Notes: Do not operate 1, 1.5, or 2 H.P. units on 208v. or premature motor failure will occur and will not be covered under warranty For use in decorative fountains only. NOT designed for use in swimming pools or in fountains that share water common to a swimming pool or spa A suitable Class ‘A’ type G.F.C.I. protected motor control circuit must be provided by installer, for human safety and operation, per Section 680 of the N.E.C. Documentation & Downloads 3.201 RHSP Series Brass Submersible Pump Cad File DWG | 887 KB 3.201 RHSP Series Brass Submersible Pump Cut Sheet PDF | 207 KB
