The RSPP-95 Series Self-Priming Pump is available in 4, 5 and 7.5 HP. All three models are available in both single and 3-phase power. It features a one-piece thermoplastic housing with integral strainer basket and an easy on/off two-piece see through lid. The RSPP-95 Series has a non-corrosive plastic impeller with heavy duty mechanical seal, suction and discharge that are equipped with 4″ quick disconnect unions for easy installation and maintenance (union & lid wrench included). Additionally it contains a heavy duty energy efficient totally enclosed fan cooled (TEFC) motor. Power requirement: 208-230/, 1Ph or 208-230/460V, 3Ph. Please refer to the cut sheet for technical and hydraulic data as well as pump curves. Notes: Pump motor must be adequately guarded against heat, dirt, and moisture. Pump room must be ventilated at a rate of 25 CFM per horsepower. Maximum recommended suction lift: 4′ above lowest pool water level; suction side of pump will require a check valve for self-priming applications (by installer). Documentation & Downloads 3.110 RSPP Series Self-Priming Pump Cad File DWG | 2 MB 3.110 RSPP Series Self-Priming Pump Cut Sheet PDF | 250 KB
